Water supply interrupted — lacks water

The system has detected that water is not reaching the internal tank. The machine cannot operate without a consistent water supply.

This is typically caused by a closed or partially closed inlet valve, a kinked water supply hose, low mains water pressure, or a disconnected water line. It can also occur if the inlet filter is clogged with sediment.

Check that the water supply valve is fully open and the inlet hose is not kinked or bent. Verify that your mains water pressure is within the required range (0.1–0.4 MPa). Inspect the inlet connection at the back panel for any blockage. If the issue persists after these checks, contact support for further assistance.